Skip to content

Vinyl Setup: from cartridge to a tuned playback chain, step by step

A guide that ties the three turntable calculators together. Type once what you know about the cartridge and the arm (from data sheets or your own measurements), then open each calculator with the figures already in: geometry, tracking force and the arm–cartridge resonance. Whatever you leave at 0 stays empty: the guide holds no cartridge or arm figures and fills nothing in for you.

Your figures

The cartridge (from the maker's data sheet)

g
g
g
g
cu
Measured at

The arm (from its data sheet or measured)

g
g
g
mm

Type only what you have from data sheets or your own measurements. 0 means “not known yet”, and that step tells you what is missing.

The steps
  1. 1. Mount the cartridge and align the geometry

    Fit the cartridge to the headshell, mount the headshell on the arm and align with a protractor on the null points of a geometry. The calculator gives the null points, the overhang and a printable protractor.

    Missing: Pivot to spindle distance

  2. 2. Set the tracking force

    Set the counterweight to the force on the cartridge data sheet, then check with a stylus gauge. The calculator compares the reading with the cartridge's range, allowing for the gauge's tolerance.

    Missing: Recommended minimum force, Recommended maximum force

  3. 3. Check the arm–cartridge resonance

    The arm's mass together with the cartridge and its compliance gives a low resonance; roughly 8 to 11 Hz is the usual zone. If it lands far off, better to know before you mount or buy.

    Missing: Arm effective mass, Cartridge weight, Compliance

  4. 4. Go again after any change

    A new cartridge, headshell or weight changes the mass and the force: repeat steps 2 and 3, and step 1 for a new cartridge.

The ideas behind the controls

A guide, not a calculator
The formulas are in the three calculators; here you type the figures once and they go into all three without retyping.
Check the resonance early
A cartridge too stiff or too soft for the arm's mass cannot be fixed by adjustments; it is cheaper to find out before mounting.

What this tool cannot tell you

  • The guide knows nothing about your cartridge or arm; every figure is typed by you, from data sheets or measurements.
  • The resonance here is an estimate with a fixed ±15 % tolerance; use the resonance calculator for your own tolerance.
  • It does not cover azimuth, VTA/SRA or stylus cleaning.

Where the formulas come from

  • The cartridge's and the arm's data sheets — The only source for force, compliance and mass; the guide holds no cartridge or arm figures.
  • The order of the steps — Common practice in setting up a turntable, not a measurement; each step has its formulas and sources in its own calculator.

Frequently asked questions

In what order do I set up?

Alignment, then tracking force, then the resonance check; after any cartridge or headshell change, start again from the force. The order is common practice, not a standard.

Where do the figures come from?

Force and compliance from the cartridge data sheet, effective mass from the arm's data sheet. The guide has no cartridge figures and invents none.

Is anything sent anywhere?

No. The figures stay in the page's address and in your browser; nothing goes to a server.

Vinyl Setup: from cartridge to a tuned playback chain, step by step · Strunin