Skip to content

Stylus tracking force: set-up, gauge and anti-skating

The force the stylus puts on the record comes from the cartridge data sheet; it is not calculated. Look up the maker's recommended range, type it in, set the arm, measure with a stylus gauge and see whether the reading, with the gauge's tolerance, falls inside the range.

The cartridge's range

1. The maker's recommended range

Search with Google AISearch on GoogleType the cartridge model to enable the search.

The button opens Google in a new tab with the question already written; the tool sends nothing and does not read the result. Check the maker's data sheet, not a forum, and copy the figures here.

g
g
g
The gauge reading

2. What the gauge shows

g
g

Cheap gauges are off by a few hundredths of a gram; 0.05 g is a cautious value, read yours from the gauge's sheet.

The counterweight

3. How far to move the counterweight (optional)

For arms with no force scale or an unreliable one: once you have found the zero balance, you move the counterweight toward the pivot by a distance from a moment balance. It is a statics estimate; friction and the cable move it, so the gauge has the last word.

g
mm

The tonearm geometry tool computes it; or take it from the arm's data sheet.

Fill in the counterweight mass and the effective length.

The set-up steps

The steps, in order

  1. Mount the cartridge, set the geometry and leave the arm's force dial at 0.
  2. Balance the arm: turn the counterweight until the arm floats level, free, without touching the record.
  3. Without touching the counterweight, set the force dial to 0 (on some arms you turn the ring, on others you read its scale).
  4. Turn the counterweight to reach the target force, then check with the stylus gauge at the height of the record's surface.
  5. Read the gauge, enter the value above and correct if it falls outside the range.
  6. Set anti-skating to the starting point above and adjust by ear or with a test record.

The ideas behind the controls

Force is not calculated
The range comes from the cartridge data sheet. The tool holds no cartridge figures: you bring the source, it checks the reading.
The gauge has an error too
A reading of 1.52 g on a ±0.05 g gauge could be 1.47 g: under a 1.5 g minimum. That is why the result is a range.
The best value
If the maker gives a best value, that is the target; otherwise the middle of the range is a reasonable start.

Common mistakes

  • Taking the range from a forum instead of the maker's data sheet.
  • Measuring with the gauge at a height other than the record's surface.
  • Touching the counterweight while setting the force dial to 0.
  • Believing a reading right on the edge of the range is surely inside.

What this tool cannot tell you

  • The tool knows nothing about your cartridge; you type the range from the data sheet.
  • The anti-skating figure is a rule of thumb; the real skating force depends on the arm, the stylus and the record.
  • It does not replace a good stylus gauge, nor setting azimuth, VTA/SRA or geometry.
  • The maker's range is for a new stylus; a worn one may behave differently.

Where the formulas come from

  • The cartridge maker's data sheet — The only source for the force range; the tool holds no cartridge figures.
  • The rule that anti-skating equals tracking force — Common practice, not a measurement; not tested by the tool.

Frequently asked questions

What is a stylus gauge?

A small scale, digital or balance type, on which you set the stylus to see the force it puts down; used at the height of the record's surface.

Can I use a kitchen scale?

No: it lacks hundredth-of-a-gram resolution and cannot sit at the record's height.

What is anti-skating?

A small force toward the outside of the record that counters the arm's tendency to be drawn inward.

Stylus tracking force: set-up, gauge and anti-skating · Strunin