Online violin tuner
Play a violin string and see which note the tuner hears, how far off you are in cents and which string you are heading for (G, D, A or E). There is a needle and a stroboscope, a reference tone for every string and a reference A between 415 and 466 Hz. The microphone sound is processed in the browser and goes nowhere.
Note
—
Play a string…
Offset
—
Frequency
—
The ideas behind the controls
- The strings and notes
- The four strings are tuned G3, D4, A4 and E5, in fifths (source: Fletcher and Rossing, p. 237). The tuner picks the string closest to the sound it hears, so play one open string at a time.
- A common order
- In practice people start from A, then D, G and E, with the pegs for big corrections and the fine tuners for small ones. This is common practice, not a standard, and we do not attribute it to any source.
- Which A?
- The ISO 16 standard fixes A4 at 440 Hz. Many orchestras play higher and baroque music lower, so the A can be set between 415 and 466 Hz; match the group you play with.
- Equal temperament or pure fifths
- Choose “Pure fifths from A” to tune each string at a 3:2 ratio to its neighbour. G3 then comes out at 195.56 Hz instead of 196.00. Galamian (p. 22) writes that no one system of intonation suffices alone and that the player adapts to the accompaniment; that is why both are offered.
Common mistakes
- Tuning in a noisy room: the tuner may take the noise or another string for the note.
- Playing two strings at once: play a single open string at a time.
- Tuning to a different A from the group you play with (440 against 442 Hz, for example).
What this tool cannot tell you
- The tuner was checked with generated signals in tests, not with a real violin.
- It does not replace a teacher or a luthier: it says nothing about the state of the strings or the instrument.
- What is said here about the order of tuning and about pure fifths is common practice, not a standard.
Where the formulas come from
- ISO 16:1975, Acoustics: standard tuning frequency — A4 = 440 Hz. The text of the standard was not read (paid); the value appears in the ISO catalogue and secondary sources.
- N. H. Fletcher, T. D. Rossing, The Physics of Musical Instruments, Springer, 1991 — p. 237: the G3, D4, A4, E5 tuning; p. 238: total string tension, typically about 220 N; p. 276: viola and cello tuning.
- I. Galamian, Principles of Violin Playing and Teaching, Prentice-Hall, 1962 — p. 22: on “tempered” and “natural” intonation and adapting to the accompaniment. In the pages read, the book says nothing about tuning the open strings in pure fifths.
Frequently asked questions
What strings does a violin have?
Four, tuned G3, D4, A4 and E5 (Fletcher and Rossing, The Physics of Musical Instruments, 1991, p. 237).
Why does G read about 4 cents low in pure-fifths mode?
A pure fifth is 701.96 cents, an equal-tempered one 700. Counting from A in pure fifths, G3 ends up 3.9 cents below the equal-tempered note and E5 2.0 above. The difference is calculated, not measured on an instrument.
Is the microphone sound sent anywhere?
No. The sound is analysed in the browser. The only trace is the tuner setting in your browser (the reference A, the preset and the reference sound), which you can clear in the browser settings.
How accurate is it?
We give no accuracy figure. Detection was checked on generated signals, not on a real violin, and depends on the microphone and the noise in the room.