Skip to content

Online drum tuner

Tap lightly near a lug and see the pitch of the sound in Hz with the microphone, to bring all the lugs of one head to the same pitch. Pick the drum type and calculate starting targets for the top and bottom heads; the centre-hit fundamental is measured separately. The sound is processed in the browser and goes nowhere.

Put this tuner on your site

Drum tuner
Drum
Hz

A starting value you change yourself; it is not a recommendation.

Resonance
Higher head

Calculated targets (a starting point)

Top: 150.0 Hz (D3 +37¢)

Bottom: 185.0 Hz (F♯3 +0¢)

What you measure
What you measure

Mute the opposite head, place the microphone close and tap lightly about an inch from a lug. Each lug moves on to the next after 3 taps.

Last hit

No hit yet

Number of lugs
The head you are measuring
12345678

Tap at least two lugs.

The ±15 cents threshold is this tool's choice, not a standard.

LugHzAgainst the medianAgainst the target
———
———
———
———
———
———
———
———

The ideas behind the controls

Two different measurements
Near a lug, with the opposite head muted, you measure that head's pitch. In the centre, with both heads open, you measure the whole drum's fundamental. They are different values and must not be mixed; the guide used says lug pitch is 1.2 to 2.3 times the fundamental on typical drums.
Matching the lugs
The aim is for all the lugs of one head to give the same pitch. The tool shows how far each is from the median, in cents, and says whether the gap between the highest and the lowest is small. The threshold is our choice.
Targets are starting points
The ratios come from a tuner maker's guide, for typical drums. Depth, heads, bearing edge, damping and the room change the result. Adjust by ear.
Resonance
With both heads at the same pitch, resonance (sustain) is greatest; the more they differ, the lower it gets, the guide says. The choice is a matter of taste and situation.

Common mistakes

  • Hitting hard or in the centre when measuring a lug: the head answers with several pitches at once.
  • Not muting the opposite head: the two heads mix and the reading jumps.
  • Relying on a single hit: each lug's reading is the median of its last three.

What this tool cannot tell you

  • Detection was checked with synthetic hits in tests, not with real drums.
  • A drum sound dies quickly and has no clean harmonics; the reading may jump an octave or be missing. Hit more softly or repeat the hits.
  • Phones and small microphones reproduce sounds below about 60 Hz poorly, so a bass drum is hard to measure.
  • The target does not know your drum; it does not replace the ear.

Where the formulas come from

  • Starting rules from a drum-tuner maker — The source of the ratios between the fundamental and the lug pitch (1.75; 1.85 and 1.5; 2.0 and 1.4; 2.3 and 1.2), of the snare's fifth rule with a 400 Hz cap, and of the bass drum's fifth. They are given for typical drums as starting points, not a standard, and no independent source was found to confirm them. The values in the source's tables are not copied.

Frequently asked questions

Why tap near a lug and not in the centre?

Near a lug you measure that head's pitch. In the centre you hear the whole drum. They are two measurements, which the tool keeps apart.

Where do the target values come from?

From a tuner maker's guide formulas, applied to the fundamental or pitch you type in. There is no correct value for a drum of a given size; no table on this page is a recommendation.

Is the sound sent anywhere?

No. The sound is analysed in the browser. The page saves nothing about you.

Online drum tuner · Strunin