Skip to content

Tape head azimuth: phase between channels, angle and loss

A tilted gap reads the two tracks at slightly different moments: a tone recorded the same on both channels comes back with a phase difference and, over a wide track, loses level at high frequencies. The tool measures the phase difference in degrees on the stereo input or from a file, turns it into an angle from the track spacing you enter, and estimates the loss from your track width.

The machine

1. Your machine's figures

Hz

Common practice: 10 kHz at 7.5 ips and 15 kHz at 15 ips. It is not a rule; it depends on the alignment tape you have. For this speed 10 kHz is usually used.

Tape speed
mm

From the machine's data sheet or measured on the tape. Without it I cannot give the angle. 0 = unknown.

mm

The track's width counts, not the head gap's. Without it I cannot give the loss. 0 = unknown.

Recorded wavelength: 19.05 µm.

Live measurement

2. Live measurement on the stereo input

Play an alignment tape (or your own tone) on the machine and connect its output to the computer's stereo input. The browser asks for access to the input; nothing is sent and nothing is recorded.

Test tones

3. Test tones for recording

For the record head: you record the tone, then play it back on a playback head already aligned with a reference tape. A tone recorded on a misaligned machine cannot set the playback head.

dB

A lower level at high frequencies is common practice so as not to saturate the tape; set it by the machine's VU meter.

From a file

4. Phase from a file

Load a stereo recording of the alignment tape (WAV, FLAC, MP3). The file stays in the browser.

The ideas behind the controls

Phase is more sensitive than level
Near zero the sum's level barely changes; the phase in degrees shows clearly, so you adjust more finely.
Calibrate the input
A loopback cable shows the sound card's own offset so you do not blame the head for it.
Follow it in time
From a file you see whether the phase stays or wanders: tape moving on the head or an unsteady tape path.

Common mistakes

  • Taking the gap length as the track width: the loss would come out 0 for any error.
  • Aligning the playback head with a tone recorded on the same misaligned machine.
  • Forgetting that phase repeats every 360°: a large error can look small.
  • Leaving processing (echo cancelling, automatic gain) on for the input; it spoils phase and level.

What this tool cannot tell you

  • The angle comes from the measured phase and the track spacing you enter; if either is wrong, the angle is wrong.
  • The loss assumes a uniform track and an ideal tilt; real tapes have other losses too.
  • There are no “well aligned” thresholds: what is acceptable depends on the machine and how much the highs matter.
  • A browser can add a small delay between channels on some cards; that is why the loopback calibration exists.
  • The suggested test frequency is common practice, not a standard.

Where the formulas come from

  • Azimuth loss: 20·log10|sin x / x|, x = π·w·tan θ / λ — w = track width, λ = speed / frequency. The standard form; computed here, not checked on a machine.
  • Your machine's alignment tape — The only reference for playback; a tone generated here helps with the record head.

Frequently asked questions

What is azimuth?

The angle between the head gap and the perpendicular to the tape's direction. The gap should be square to the tape.

Why the phase between channels?

A tilted gap reads the tracks at different moments; the time difference becomes a phase difference, larger at high frequencies.

What is a goniometer?

A display where each sample is a point: left against right, rotated by 45°. Alike channels give a vertical line.

Tape head azimuth: phase between channels, angle and loss · Strunin