Skip to content

Magnetic tape: length, time, what is left and whether a programme fits

A reel of tape is a spiral: the length comes from the ring's area divided by the thickness. The usual mistake is taking the flange diameter as the tape's diameter; a real reel does not fill to the rim. Here you calibrate the reel from the length printed on the box, then find what is left from a measured diameter and whether a programme fits.

The reel and the tape

1. The tape and the reel

in

Measure yours; 2.25 inches is only a starting value.

µm

The values below are nominal (base plus coating). Enter the measured thickness or the data sheet value if you have it.

Speed

Calibrate the reel from the box

From a full reel's printed length and the tape thickness, the tool works out the diameter the reel really fills to. It holds no table of reels.

ft

A full reel fills to 5.71 inches.

The full reel: Length

365.8 m

One pass

32.0 min

All passes

64.0 min

2×

What is left

2. What is left on the reel

in

Measure the tape, not the flange.

To get an answer, measure the tape's diameter.

Does the programme fit?

3. Does the programme fit?

min
m

Tape needed

290.8 m

Tape diameter at the end

5.19 in

Of the full reel

79 %

It fits on the calibrated reel.

The ideas behind the controls

Calibrate once
A full reel with the length from the box gives the real fill diameter; after that you only need the measured diameter.
Thinner tape gives more time
But it is more fragile and may print through more. Choose by what you record.
The whole programme first
Enter the programme length and the speed: find out whether it fits without learning at the end that it does not.

Common mistakes

  • Taking the flange diameter as the tape's diameter: the length comes out nearly two thirds too large.
  • Mixing up the tape thickness with the magnetic layer's: the total thickness counts.
  • Forgetting that a four-track stereo tape has two passes: the time doubles against one pass.

What this tool cannot tell you

  • The spiral is a model: real winding is not perfectly tight, so the length is an estimate within a few percent.
  • The thicknesses in the list are nominal; real tapes differ and stretch with age.
  • There is no table of reels: the fill diameter comes from your own box, not a catalogue.
  • Leader and splices are only counted through the margin you enter.

Where the formulas come from

  • The spiral's geometry: L = π/4 (D² − d²) / t — The standard formula for a wound reel; the real fill diameter comes from calibration.
  • Nominal thicknesses 0.5 / 1 / 1.5 / 2 mil — Usual for studio tapes; your tape's data sheet has the correct value.

Frequently asked questions

Why does the flange diameter not work?

A 7 inch reel does not fill to 7 inches; the tape reaches about 5.7 inches for 1200 ft of 1.5 mil. That is why the length from the flange comes out far too large.

What is a pass?

One run of the tape from end to end. Two-track stereo has one; four-track has two (one in each direction).

What is a mil?

A thousandth of an inch, 25.4 µm.

Magnetic tape: length, time, what is left and whether a programme fits · Strunin