Surround speaker placement: 5.1, 7.1 and Dolby Atmos
A surround system sounds right mostly through geometry. Set the room, the format and the seat position: the tool places each speaker at the angles in Dolby's guidelines (which start from ITU-R BS.775), drawn to scale around the seat, and tells you what delay to give each channel so the sound arrives together. These are geometry rules, not a calibration: for your real room, measure.
Configuration
5.1
5 speakers · 1 subwoofer
Front left/right angle
±30°
from the centre line
Surround angle
±110°
from the centre line
Largest delay
6.3 ms
on Surround left
● Ear-level speaker▢ Ceiling speaker
The ideas behind the controls
- Centre line
- The line between the seat and the middle of the screen. Angles are measured from it, positive to the right.
- Height speakers
- Dolby's guide describes the ceiling pairs by a side-view angle: front 45° (30–55°), middle 90° (65–100°), rear 135° (125–150°).
- Equal distance
- Ear-level speakers should be equally far from the seat; if that is not possible, the others are delayed so the sound arrives together.
Common mistakes
- Putting the seat against the back wall: the surrounds end up too close or in the wall.
- Putting height speakers straight above the seat when the format asks for front and rear pairs.
- Treating the plan as a calibration: after placing them, run the receiver's automatic calibration and check by listening.
What this tool cannot tell you
- The default angles are the middle of the guidelines' ranges (7.1: surrounds 100°, rears 140°); the choice is the tool's.
- The three front speakers stand on the front wall, so the centre is nearer than the pair; surrounds stand on the front pair's circle, or closer if a wall stops them. The exact place of the ceiling speakers (in line with the front pair) is the tool's reading of the guide.
- A 30° front pair needs a fairly wide room; in a narrow one the pair moves in and can leave the 22–30° range, which the tool shows.
- Geometry only: it does not model reflections, room modes, furniture or the type of speaker.
- Not checked with a receiver or a real measurement in this session.
Where the formulas come from
- Dolby Atmos Home Theater Installation Guidelines — Read directly (PDF): ear-level speakers follow ITU-R BS.775-3 and share one height, typically 1.2 m, ideally equidistant or delay-compensated; front 22–30°, surround 90–110°, rear 135–150°; height speakers front 30–55° (45°), middle 65–100°, rear 125–150° (135°); ceiling speakers at least twice the ear height; rules for extra pairs (wide, centre surround and so on). The 5.1 range of 90–120° joins Dolby (90–110°) with ITU-R BS.775 (100–120°, from secondary sources).
- EBU Tech 3276 — Ears at least 1.5 m from the side and back walls; given for stereo, used here as a guide.
Frequently asked questions
Where do the angles come from?
From the "Dolby Atmos Home Theater Installation Guidelines" and Dolby's per-format guides; the ear-level ones start from ITU-R BS.775-3.
Why delays?
Speakers nearer the seat arrive earlier; the delay, (largest distance − the speaker's distance) / 343 m/s, aligns them. Receivers call it distance or channel delay.